Magnet Wire

American Spool

American Spool Configurations

Magnet Wire Supplier

European Spool

European Spool Configurations

Magnet Wire Wholesale

Southeast Asia Spool

Southeast Asian Spool Configurations

:: Copper Magnet Wire / Winding Wire

Certified OFHC* (CDA 10100)
The most important characteristic of oxygen-free high-conductivity copper is that it can be heat treated in a reducing atmosphere without embrittlement. Certified OFHC at 99.99% minimum purity displays the inherent qualities of copper to the highest degree.

OFHC* Copper (CDA 10200)
OFHC copper is produced by converting cathodes under very controlled conditions, thereby nearly eliminating all other elements. Where electrolytic copper has purity of 99.0%, OFHC copper has a minimum purity of 99.95%. (Silver is counted as copper.)

ETP Copper (CDA 11000)
Electrolytic Tough Pitch copper is the most widely-used copper for electronic products based on its optimum combination of workability, performance, and economy. For those manufacturing applications in which the presence of from 0.02% to 0.05% oxygen is not critical, ETP copper is specified for most intermediate and end users.

Magnet wire is a copper wire covered with thin insulation. It is used in the construction of transformers, inductors, motors and electromagnets; among other applications. However, it is not magnetic itself.

The wire itself is most often fully annealed, electrolytically refined copper. Aluminum magnet wire is sometimes used for large transformers and motors. However, because of its lower electrical conductivity, an aluminum wire must have 1.6 times the cross sectional area as a copper wire to achieve comparable DC resistance. Smaller diameter magnet wire usually has a round cross section. Thicker magnet wire is often square or rectangular (with rounded corners) to permit more efficient use of available winding space. Older insulation materials consisted of cotton, paper or silk and were useful for lower temperature applications (up to 105°C). Modern magnet wire typically uses one to three layers of polymer film insulation, often of two different compositions, to provide a tough, continious insulating layer.

Magnet wire insulating films use (in order of increasing temperature range) polyurethane, polyamide, polyester, polyeseter-polyimide, polyamide-polyimide (or amide-imide), and polyimide. Polyimide insulated magnet wire is capable of operation at up to 250°C. The insulation of thicer square or rectangular magnet wire is often augmented by wrapping it with a high-temperature polyimide or fiberglass tape, and completed windings are often vacuum impregnated with an insulating varnish to improve insulation strength and long-term reliability of the winding.

Film insulation for individual conductivity wire. Electric tough pitch copper.

Thermal Class
Insulation Type
NEMA Standard
IEC Standard
105°C
MW15C
NONE
155° C
MW79C
317-20
MW80C
317-21
180°C
MW82C
317-51
MW83C
NONE
MW30C
317-8
MW76C
NONE
MW77C
317-23
MW78C
NONE
NONE
317-37
200°C
MW44C/MW43C
NONE
MW45C/MW46C
NONE
MW74C
317-42
MW35C/MW36C
317-13/317-29
NONE
NONE
240°C
MW16C/MW20C
317-7/317-30

We Comply with IEC and NEMA Standards

Technical Information on Magnet Wire

 
Version 4.3.3
Home    |    Site Map    |     Links    |    Legal    |     About    |     Privacy Policy
Phone: 330-244-8501 | Fax: 330-244-8561
PO Box 2153 North Canton, Ohio 44720
Copyright © 2015 HSM Wire International, Inc. All Rights Reserved.